PHYSICAL TOLERANCES for POLYETHYLENE and POLYPROPYLENE

1). DOWN WARP: No more than 1/4" on gauges .055 & below No more than 1/8" on gauges above .055

2). UP WARP: None allowed on any gauge

3). EDGE CURL: 1/8" up curl, 1/8" down curl

4). WAVY EDGES: No more than 3 per any 24" of length, 1/8" max curl height measured from flat a surface

5). TREAT: Minimum treat level to be 56 dyne

PHYSICAL TOLERANCES for PAPER/SQUARE CUT POLY SHEET
No sheet will be out of square more than +/- 1/32" for each paper/square cut piece

SQUARENESS
A physical measurement is taken diagonally across all corners of the sheet as shown, with the difference not to exceed 1/4 inch or a maximum of 1/6 inch difference between the two diagonal measurements in a 24" x 24" sheet.